Free generator · Runs in your browser

Tolerance test generator Know your gap.

Print a labelled spin test or peg test and find the exact clearance your printer and filament need for moving and fitting parts.

  • Free and privateNothing to install
  • Three testsSpin, peg fit and hole accuracy
  • Labelled gapsRead the answer off the part
  • Ready to sliceSTL and 3MF files

Drag to rotate · Scroll or pinch to zoom · Arrow keys when focused

Size
—
Filament
—
Parts
—
Fits
—

Start from

Test

Test type
Hole sizes

Gaps and labels

0.15 mm
0.50 mm
0.050 mm

Up to ten gaps per print.

Size

10.0 mm
6.0 mm

Colours

Download

Building the preview…

Print it well

    Everything is built on this device. Nothing you type or upload is sent anywhere.

    Advertisement

    The method

    Find your printer’s real clearance

    Every printer, nozzle and filament prints holes a little small and pins a little large. A tolerance test measures by how much, so moving parts, lids and snap fits work first time. Print it once per material.

    1. Choose a test. The spin test checks print-in-place gaps; the peg test checks parts you assemble; the hole accuracy test shows how far holes and pins print from their nominal size.
    2. Print it flat, without supports, at your usual settings.
    3. Read the result. The smallest gap that moves freely is your number.

    Typical values

    Clearances to expect on FDM printers

    JointTypical gap per sideSource
    Print-in-place moving parts0.3 mm or morePrusa Knowledge Base
    PLA print-in-place, tuned printer0.20–0.30 mmSovol
    Hinges, 0.4 mm nozzle0.30–0.40 mmQidi
    PETGadd 0.05–0.10 mmSovol

    Vertical gaps behave differently: a gap under an overhang droops, so give it an extra layer.

    Spin test

    How the spin test works

    Each rotor widens at 45° to a waist and narrows again, and its ring follows the same shape a gap away. The 45° faces print without supports, and the ring holds the rotor captive, so the only way it turns is if the gap stayed open. Elephant’s foot is the usual reason the smallest gaps fuse at the bottom.

    Questions, answered

    Which gap should I design with?

    Use the smallest gap that worked reliably, plus 0.05 mm of margin for print-to-print variation.

    Why did every rotor fuse?

    Check the first layer: an over-squished first layer (elephant’s foot) bridges small gaps. Reduce first-layer flow or add elephant’s foot compensation in the slicer.

    Do I need to retest for each filament?

    Yes. PETG and TPU usually need larger gaps than PLA.

    Sources

    Print advice is a starting point drawn from these references, checked on 2026-11-07. Community posts are one maker's experience, not a specification.

    1. Modeling with 3D printing in mind Prusa Research
    2. Print-in-place 3D printing: hinges, joints and moving parts Sovol
    3. How to 3D print interlocking parts and assemblies Qidi