Free generator · Runs in your browser

Stencil generator Bridges built in.

Turn any design or text into a printable paint stencil. Islands are found and tied back with bridges automatically, so nothing falls out.

  • Private by designDesigns stay on this device
  • Automatic bridgesEvery island held in place
  • See the bridgesHighlighted before you print
  • Ready to sliceSTL and 3MF files

Drag to rotate · Scroll or pinch to zoom · Arrow keys when focused

Size
—
Filament
—
Parts
—
Fits
—

Start from

Design

Start from
Typeface

Sheet

120.0 mm

The longer side of the cut-out design.

12.0 mm
0.6 mm

0.6 mm (three 0.2 mm layers) is the common choice.

4.0 mm

A stiffening band around the edge, so thin sheets stay flat.

1.0 mm

For stencils used from the back, such as on glass.

Bridges

1.4 mm

1 mm is a practical minimum; 1.2 mm or more prints reliably.

Direction
1.00 mm²

Download

Building the preview…

Print it well

    Everything is built on this device. Nothing you type or upload is sent anywhere.

    Advertisement

    The method

    Make a stencil in three steps

    Dark areas of your design are cut out of a thin sheet. Parts of the sheet that would be left floating, the islands in the middle of letters like O and A, are tied back with bridges automatically.

    1. Add a design or type text. Bold shapes and heavy typefaces stencil best.
    2. Size the sheet. Leave a generous margin so overspray stays on the stencil.
    3. Check the bridges (lime in the preview) and download.

    Bridges

    Islands and bridges explained

    An island is a piece of the stencil sheet entirely surrounded by cut-out area, such as the centre of an O. Without support it falls out and the letter paints as a solid blob. A bridge is a narrow strip left uncut to hold the island in place.

    SettingRecommendationWhy
    Bridge width1.2–1.5 mmAbout three nozzle widths: strong enough to survive cleaning, narrow enough to paint over.
    DirectionShortest, or vertical for textVertical bridges read more naturally in lettering.
    Sheet0.6 mm PETGFlexible, solvent-resistant and quick to print.

    Painting

    Painting with a printed stencil

    • Hold it flat with low-tack tape or repositionable spray adhesive.
    • Spray light coats at a right angle, a few seconds apart, rather than one heavy coat.
    • Clean it straight away while the paint is wet.

    Questions, answered

    Why does my stencil have lines across some letters?

    Those are bridges holding islands in place. Without them, the centres of letters like O, A and B would fall out.

    Which material is best?

    PETG is popular: it bends without cracking and resists paints and solvents. PLA works for one-off jobs.

    Can I make thicker stencils?

    Yes, up to 3 mm, for tracing with a pen or for durable shop stencils.

    Is my design uploaded?

    No. It is processed on your device only.

    Sources

    Print advice is a starting point drawn from these references, checked on 2026-11-07. Community posts are one maker's experience, not a specification.

    1. Stencil Wikipedia
    2. Designing for stencils Ponoko
    3. Nickel Stencils: font of the month David Jonathan Ross