The method
How a maze gift box works
The container has a maze cut into its outside wall. The lid slides over it, and small pins inside the lid ride in the maze's grooves. The lid only sits fully closed when its pins reach the pocket at the bottom of the maze, so the only way to the gift is to solve the maze back up to the entrance at the top.
- Choose what goes inside. The sizes leave a few millimetres of space all round.
- Pick a difficulty and a maze number. Every number is a different maze; keep the number to make the same one again.
- Print both parts. No supports.
- Close it up. Line up the marks, push the lid down and follow the solution to the bottom pocket. Then wrap it.
Sizes
What fits inside
| Gift | Inside | Why |
|---|---|---|
| Gift card | Ø57 × 89 mm | A standard ID-1 card is 85.60 × 53.98 mm and stands upright with room to tip it out. |
| Banknotes | Ø30 × 80 mm | A roll of US notes (2.61 in, 66.3 mm wide) or euro notes (62–77 mm wide on today’s series). |
| Small gift | Ø45 × 40 mm | Rings, earrings, earbuds, a key or sweets. |
| Custom | Ø20–100 × 25–160 mm | Measure your gift and add 2–3 mm all round. |
Printing
Printing it well
- No supports. The container prints upright and the top of every groove slopes at 45°. The lid prints upside down; its pins are short pegs that print fine without support.
- Clearance. 0.35 mm suits most printers. If the lid binds, raise it to 0.45 mm; if it rattles, lower it. The tolerance test generator finds your printer’s number.
- Material. PLA or PETG at 0.2 mm layers. A brim helps tall containers.
- Two colours. Print the lid and container in different colours; it makes the maze easy to see.
Solving
Tips for the person opening it
Turn and push the lid gently: the pins follow the grooves. Dead ends are part of the fun. If they get stuck, the solution map shows the way out, with the maze unrolled flat (its left and right edges join up).
Questions, answered
Is it free to use?
Yes. No account, no watermark, no limits.
Can I make the same maze again?
Yes. The maze number makes the same maze every time with the same size and difficulty. A shared link keeps every setting.
Does the box lock?
The lid sits closed only in the home pocket and can’t come off until the pins are back at the entrance. It is a puzzle, not a lock: someone determined can still pull it apart.
How long does it take to print?
The gift-card size uses about 115 g of filament and the banknote size about 55 g; both take a few hours on most printers. The readout shows the filament for your settings.
Sources
Print advice is a starting point drawn from these references, checked on 2026-11-08. Community posts are one maker's experience, not a specification.
- ISO/IEC 7810: identification card sizes (ID-1, 85.60 × 53.98 mm) Wikipedia
- Currency FAQ: size of paper money (2.61 × 6.14 inches) US Department of the Treasury (archived)
- Euro banknotes: sizes Oesterreichische Nationalbank