Free generator · Runs in your browser

Vase generator One wall. One line.

Shape a vase or lamp shade with twists, ribs and waves, and download a solid model that prints beautifully in spiral vase mode.

  • Free and privateNothing to install
  • Five profilesPlus sides, twist, ribs, waves
  • Vase-mode readyOne closed solid
  • Ready to sliceSTL and 3MF files

Drag to rotate · Scroll or pinch to zoom · Arrow keys when focused

Size
—
Filament
—
Parts
—
Fits
—

Start from

Shape

Profile
160.0 mm
80.0 mm
70.0 mm
14.0 mm

Pattern

0.0
0.25
120.0 °
24.0
1.6 mm
0.0
3.00 mm
Surface texture
14.0
1.8 mm

Finish

Download

Building the preview…

Print it well

    Everything is built on this device. Nothing you type or upload is sent anywhere.

    Advertisement

    The method

    Design a vase for vase mode

    Spiral vase mode prints a solid model as a single continuous wall, rising steadily without a seam. This generator makes exactly the kind of model vase mode needs: one closed solid with one outline per layer. Shape the profile, add pattern, then switch on vase mode in your slicer.

    Slicers

    Vase mode in your slicer

    SlicerSettingWhat it does
    PrusaSlicerSpiral vaseOne perimeter, no infill, no top layers; bottom layers you choose.
    CuraSpiralize outer contourA single wall with a solid bottom.
    Bambu StudioSpiral vaseA single wall with solid bottom layers and no seam.

    Vase mode prints one object at a time and ignores any inside detail, so the model is a plain solid.

    Printing

    Stronger, better-looking vases

    • Wider lines: 0.6–0.8 mm on a 0.4 mm nozzle make a stiffer wall; very wide lines can bulge at sharp corners.
    • Bottom layers: 3 is the usual default; 0 for an open lamp shade.
    • Overhangs: keep the profile within about 45° of vertical.
    • Water: a single wall is rarely watertight; seal it or use dried flowers.

    Questions, answered

    Why is the downloaded model solid?

    Vase mode needs a solid model: the slicer turns its outside surface into a single wall. If you print it without vase mode, it prints as a solid block.

    Can I make a lamp shade?

    Yes. Switch on lamp shade, then set bottom layers to 0 in the slicer so it is open at both ends. Use LED bulbs only.

    Will it hold water?

    Single-wall prints often weep. Coat the inside with a sealant, or print a liner, for fresh flowers.

    Sources

    Print advice is a starting point drawn from these references, checked on 2026-11-07. Community posts are one maker's experience, not a specification.

    1. Layers and perimeters (spiral vase) Prusa Research
    2. PrusaSlicer print settings source (spiral vase) Prusa Research
    3. Cura printer definition (spiralize) UltiMaker
    4. How to improve wall thickness in spiral vase mode Bambu Lab community forum