Free generator · Runs in your browser

Pegboard accessory generator Hang it all.

Make hooks, shelves and cups that lock onto 5 × 15 mm slot pegboards like IKEA SKÅDIS, or print your own board tiles. No supports needed.

  • Free and privateNothing to install
  • Hooks to shelvesPlus printable board tiles
  • Drop-lock pegsPush in, slide down
  • Ready to sliceSTL and 3MF files

Drag to rotate · Scroll or pinch to zoom · Arrow keys when focused

Size
—
Filament
—
Parts
—
Fits
—

Start from

Accessory

Make

Size

40.0 mm

Wider pieces get a peg column every 40 mm.

60.0 mm
45.0 mm
4.0
6.0

Shape

4.0 mm
12.0 mm
6.0
9.0 mm
10.0 mm

Download

Building the preview…

Print it well

    Everything is built on this device. Nothing you type or upload is sent anywhere.

    Advertisement

    The method

    Accessories that lock onto a slot pegboard

    These accessories hang on pegboards with upright 5 × 15 mm slots on a 40 mm pitch, the layout used by IKEA SKÅDIS. Each peg pushes through a slot and slides down to lock behind the board. Everything prints on its side, so the pegs need no supports.

    Dimensions

    Slot pegboard dimensions

    FeatureValue
    Slot5 × 15 mm, upright, rounded ends
    Spacing40 mm between slots in a row; rows 20 mm apart, alternate rows offset 20 mm
    Board thicknessAbout 5 mm
    Peg4.6 mm wide, 8 mm tall, with a 12 mm tab that drops 10 mm to lock

    IKEA does not publish slot sizes; these come from community measurements that agree with each other. SKÅDIS is a trademark of Inter IKEA Systems; these parts are not made or endorsed by IKEA.

    Printing

    Printing strong hooks

    • On its side, as laid out: layers run along the hook, which makes it far stronger.
    • Walls over infill: 4 or more perimeters carry more than extra infill.
    • Material: PETG flexes rather than snapping under heavy tools.

    Questions, answered

    Will these fit an IKEA SKÅDIS board?

    They are made for 5 × 15 mm slots on a 40 mm pitch, the layout SKÅDIS uses. If yours is a tight fit, sand the pegs lightly.

    Can I make Multiboard or openGrid parts?

    Not here. Multiboard’s licence restricts third-party derivatives, and openGrid uses a different snap system.

    How much weight can a hook hold?

    It depends on material, walls and the board. Printed on its side in PETG with 4 walls, hooks comfortably carry hand tools.

    Sources

    Print advice is a starting point drawn from these references, checked on 2026-11-07. Community posts are one maker's experience, not a specification.

    1. boxes.py SKÅDIS generator (slot layout) Florian Festi
    2. SKÅDIS peg pattern xaviergmail (GitHub)
    3. SKÅDIS network mounts (drop-lock peg geometry) PrimroseHA (GitHub)
    4. SKÅDIS pegboard IKEA