Free generator · Runs in your browser

Spring generator Built to bounce back.

Design printable compression springs and flat flexures with closed, flat ends and live pitch and travel, ready for PETG or TPU.

  • Free and privateNothing to install
  • Coils and flexuresCompression and zig-zag
  • Live numbersPitch, gap and travel
  • Ready to sliceSTL and 3MF files

Drag to rotate · Scroll or pinch to zoom · Arrow keys when focused

Size
—
Filament
—
Parts
—
Fits
—

Start from

Type

Spring

Size

20.0 mm
30.0 mm
5.0
60.0 mm
16.0 mm
6.0

Wire

2.4 mm
1.6 mm
12.0 mm
1.20 mm
8.0 mm

Download

Building the preview…

Print it well

    Everything is built on this device. Nothing you type or upload is sent anywhere.

    Advertisement

    The method

    Springs you can print

    Printed springs use a rectangular "wire", which prints far more reliably than round wire, and closed, flat ends so they stand square. Choose a compression coil or a flat zig-zag flexure, size it, and print it in a springy material.

    Materials

    Choose the right plastic

    MaterialAs a springNotes
    PETGGoodTough and springy; a little creep under constant load.
    TPU (85A–95A)Soft springsVery flexible, great for soft returns and dampers.
    PLAPoorBrittle, and it creeps: a loaded PLA spring slowly takes a set.

    Design

    Design rules for printed springs

    • Coil gap: keep at least two layers between coils so they do not fuse.
    • Orientation: coil springs print upright; flat springs print flat.
    • Infill: 70–100%, with fine layers (0.1–0.15 mm).
    • End stops: limit travel so the spring is never crushed solid or over-bent.
    • Rest unloaded: plastic springs lose force if stored compressed.

    Questions, answered

    How strong is the spring?

    Stiffness depends heavily on the material, print settings and temperature, so test a print in place and adjust wire width, height or coil count.

    Why does my spring stay compressed?

    That is creep, common with PLA. Switch to PETG or TPU and avoid leaving it loaded.

    Can I print it lying down?

    Coil springs should print upright; lying down needs supports and is much weaker between layers.

    Sources

    Print advice is a starting point drawn from these references, checked on 2026-11-07. Community posts are one maker's experience, not a specification.

    1. The challenges of 3D printing reliable springs Hackaday
    2. How to design 3D printed springs: tips and materials Siraya Tech
    3. 3D printed flexures (presentation) Akaki Kuumeri via Core77