PolyJetManufacturer image: StratasysStratasys J5 DentaJet
PolyJet system in the Stratasys industrial printer range.
Source reviews: 2026-10-15, 2026-10-16.
Specifications are reported claims, not independent test results.
The details that matter.
Published specifications for this model. Follow a field's source for its configuration and measurement conditions; older fields refer to the profile's reference list.
| Introduction year | Not verified |
|---|---|
| Model family | Not verified |
| Process | PolyJet |
| Build envelope (X × Y × Z) | Not verified |
| Nominal box volume | Not verified |
| Enclosure | Not verified |
| Materials cited in this profile | Not verified |
| Manufacturer listing status | Listed by manufacturer |
| Regional stock and price | Check the manufacturer |
| Market grouping | Industrial · editorial grouping |
Technical specifications
| Machine dimensions (mm) | 651 × 661 × 1511 |
|---|---|
| Machine weight (kg) | 228 |
| Layer Heights (µm) | 18.75, 20.625 Mode-specific nominal layer settings, not dimensional accuracy; material compatibility varies. |
| Support Materials | SUP711 for listed dental materials; separate TrueDent Support |
| Software | GrabCAD Print |
| Connectivity | LAN TCP/IP |
| Operating Temperature (°C) | 18–25 |
| Operating Humidity | 30–70%, non-condensing |
| Power Supply | 100–240 VAC, 10 A, single phase, 50/60 Hz |
| Maximum Simultaneous Model Materials | 5 Maximum in applicable print mode, not every speed mode. |
| Tray Area (cm²) | 1174 |
| Maximum Single Part Dimensions (mm) | 140 × 200 × 190 |
Materials and intended workflow
J5 DentaJet combines up to five materials, including full-color dental-model workflows and the TrueDent denture/partial system. TrueDent uses its own support material; compatibility and intended use are specific to the material and approved workflow.
Geometry and print modes
The circular tray has 1174 cm² of printing area and the maximum individual part is 140 × 200 × 190 mm. The two listed quality/speed settings use 18.75 and 20.625 µm layers. Cartridge hot swapping in Long Print mode applies only to selected materials.
Explore the model family.
An exact introduction year has not been established in the reviewed sources.
Explore Stratasys through the generationsRead this with the specifications
Model-specific embedded specifications in the current official Stratasys catalog were reviewed on 2026-10-16. Optional accessories, material-dependent layer settings and print-mode limits are identified separately.
A larger nominal envelope does not establish better print quality. Fit depends on the configuration, usable area, supports, and orientation.
